Central Asian Research Index

Guliston davlat universiteti axborotnomasi, 2025

QISHLOQ XO‘JALIK MASHINALARINING ISHCHI ORGANLARINI QATTIQ QOTISHMALAR BILAN QOPLASH UCHUN KUKUN TANLASH

Karim Nuriyev

Гулистанский государственный универитет

Аннотация · Abstract

The article, based on the research carried out, concludes that blades overlaid with hard alloy PS-14-80 + 10% FCB (0.166 mm/km) have the minimum wear rate, and PG-US-25 has the highest (0.38 mm /km). The difference between them is 44%; a comparison of blades that differ in the location of the hardened layer showed that, regardless of the hardening material, blades with lower hardening had 10...15% higher wear resistance than blades with upper hardening, and a comparison of blades deposited with the same hard alloy,but differing in location with the same average thickness of the deposited layer, the wear resistance of a blade with a lower location is 10...20% higher than that of blades with an upper location. This leads to the conclusion that the blade profile parameters are more strongly influenced by the location of the deposited hard layer than by the material and hardness of the deposited layer. Comparative tests carried out in SAIME, SAMIS and Sredaz GOSNITI showed that shares coated with hard alloy PS-14-80 have a service life 1.2...1.7 times longer compared to PG-S27. For strengthening the working bodies of soil-cultivating machines operating under conditions of intense abrasive wear, powder made from hard pseudoalloy PS-14-80 is considered preferable, since it has high wear resistance (on average 40%) and lower cost (up to 35%) compared to high-alloy cast iron. For the formation of surfacing charge, the best performance is achieved by fluxes prepared at the Altaiselmash plant. Summarizing the research carried out, it is concluded that for carrying out research on the creation of self-sharpening working bodies in order to increase their wear resistance and service life, it is recommended to use PS-14-80 grade pseudo-alloy.

Сведения · Details