Central AsianResearch Index

INFLUENCE OF THE RATIO OF GASE CONSUMPTION N<sub>2</sub>/Ar AND MAGNETRON POWER ON THE DENSITY AND STOICHIOMETRIC COMPOSITION OF TIN<sub>X</sub> FILMS SYNTHESIZED BY MAGNETRON SPUTTERING METHOD

The films of titanium nitride were deposited by direct current magnetron sputtering on the surface of singlecrystalline silicon samples in an Ar-N 2 atmosphere for use as a diffusion barrier. The thickness and density of films were measured by X-ray reflectometry. The design of the MAGNA TM-200-01 installation has been changed to increase the supply of nitrogen into the chamber. The influences of sputtering conditions, including the flow rate of nitrogen and argon gases and their N 2 /Ar ratios in the range of 1–60 in the chamber, magnetron power of 690–1400 W on the formation of TiN x films, their density and stoichiometric composition, were studied. It is shown that the value of x is affected not only by the N 2 /Ar gas flow rate ratio, but also by the magnetron power. At the sputtering parameters 1200 W, N 2 /Ar = 30, 0.8 Pa, 320 s and 100°C, a maximum density of 5.247 g/cm 3 of a film was achieved, which corresponds to the composition TiN 0.786 = Ti 56 N 44 . The presence of nanocrystalline film of titanium nitride and the absence of a nanocrystalline titanium phase were confirmed by photographic X-ray diffraction. It was found that for the synthesis of titanium nitride as close as possible to the stoichiometric composition TiN 0.770 - TiN 0.786 , it is necessary to use magnetron power in the range of 900–1200 W, nitrogen rate of 30 cm 3 /min with low argon flows of 1–5 cm 3 /min.

Сведения

Опубликовано
2024 · Т. 21, № 3, С. 302-313
Язык
Английский
ISSN
1998-6688 · 2959-8109
Издатель
Kazakh-British Technical University
Аффилиации
Kazakh-British Technical University
Rzhanov Institute of Semiconductor Physics, Siberian Branch of the Russian Academy of Sciences