INVESTIGATION OF CONVERSION OF N-BUTANE TO LIGHT OLEFINS ON CATALYSTS Pd/ℽ-Al2O3 AND Pd/SiO2
The results of the conversion of n-butane on supported palladium catalysts in a stationary mode in the temperature range of 400-600 °C, at atmospheric pressure and a volumetric feed rate of n-butane of 250 h –1 are presented. The catalysts were obtained by the method of incipient wetness impregnation using γ-Al 2 O 3 and SiO 2 (silica gel) as supports, the palladium loading was 1 and 3%. It was found that, along with the dehydrogenation of n-butane, cracking processes occur in parallel, leading to the formation of both olefins (ethylene, propylene) and alkanes (methane, ethane, propane), isomerization of n-butane to isobutane, and other reactions. Hydrogen contained in contact gases is equivalent to the amount of dehydrogenation and degradation products. In trace amounts, non-condensed liquid products such as pentane and aromatics are present in the gas phase. The catalysts were studied by SEM-EDS to determine the morphology of catalysts and the elemental composition of individual sections of their surface, and the specific surface area of the catalysts was also determined.
Сведения
- Опубликовано
- 2026 · № 2(22), С. 696-704
- Язык
- Английский
- ISSN
- 2788-7995 · 3006-0524
- Издатель
- Shakarim University
- Аффилиации
- Al-Farabi Kazakh National University; Institute of Petroleum Chemistry, SB RAS
Institute of Petroleum Chemistry, SB RAS
A.B. Bekhturov Institute of Chemical Sciences