STUDY OF THE EFFECT OF THERMAL CYCLING AND HEATING RATE ON THE BEHAVIOR OF METALLIC BERYLLIUM IN A VAPOR-ARGON ENVIRONMENT BY THE TGA METHOD
This study investigates the behaviour of metallic beryllium under high-temperature corrosion in a water-steam-argon atmosphere under thermal cycling conditions using thermogravimetric and differential scanning calorimetric analysis (TGA/DSC). The experiments were conducted at three heating rates (10, 20, and 30 K/min), each including two thermal cycles (C1 and C2). Oxidation was evaluated by mass gain and thermal effects, and kinetic parameters ( Ea , K 0) were determined from logarithmic Arrhenius dependencies with normalisation to surface area and partial water vapour pressure. Two characteristic temperature ranges were established: initial thermal activation (775–1050 K) and high temperature (975–1170 K), as well as a transition zone between them. For the high-temperature region, the activation energy Ea = 146 kJ/mol and the pre-exponential factor K 0 = 2.41·10 −1 mg/(s·cm 2 ·Pa) were obtained. The results obtained deepen the understanding of the mechanisms of beryllium oxidation during thermal cycling and can be used to assess safety in nuclear fusion installations.
Сведения
- Журнал
- NNC RK Bulletin
- Опубликовано
- 2025 · № 4, С. 47-54
- Язык
- Английский
- Цитирований
- 2
- ISSN
- 1729-7516 · 1729-7885
- Издатель
- Republican State Enterprise "National Nuclear Center of the Republic of Kazakhstan
- Аффилиации
- RSE “Institute of Nuclear Physics” of the Agency of the Republic of Kazakhstan for Atomic Energy
Institute of Experimental and Theoretical Physics, Al-Farabi Kazakh National University; Branch “Institute of Atomic Energy” RSE NNC RK
Institute of Experimental and Theoretical Physics, Al-Farabi Kazakh National University