Central AsianResearch Index

INFLUENCE OF VARYING THE SPRAYING DISTANCE ON THE STRUCTURAL-PHASE STATE AND MECHANOTRIBOLOGICAL PROPERTIES OF 86WC-10Co-4Cr-BASED COATINGS OBTAINED BY THE HVOF METHOD

This paper presents the results of a metallographic and tribological study of 86WC-10Co-4Cr coatings obtained by the HVOF method on the Termika-3 unit at varying spraying distances. The influence of spraying distance on the coating microstructure, phase composition, as well as mechanical and tribological properties, was studied. The phase composition, microstructure and elemental distribution were analyzed using X-ray diffraction, scanning electron microscopy and energy dispersive spectroscopy techniques. The hardness was measured on a Vickers microhardness tester, the friction coefficient and wear rate were investigated using a tribometer. According to the results of the study, it was found that the optimum spraying distance for 86WC-10Co-4Cr coatings with improved wear resistance and hardness characteristics and low porosity is 300 mm.

Сведения

Журнал
NNC RK Bulletin
Опубликовано
2024 · № 3, С. 91-104
Язык
Английский
Цитирований
2
ISSN
1729-7516 · 1729-7885
Издатель
Republican State Enterprise "National Nuclear Center of the Republic of Kazakhstan
Аффилиации
Sarsen Amanzholov East Kazakhstan University
Daulet Serikbayev East Kazakhstan Technical University; “PlasmaScience” LLP