INVESTIGATION OF TRIBOLOGICAL PROPERTIES OF DETONATION COATINGS BASED ON ALUMINUM OXIDE AND TUNGSTEN CARBIDE
Detonation spraying is one of the most promising variants of thermal spraying for the deposition of wear-resistant coatings. This study aims to investigate the tribological properties of coatings deposited by the detonation method using WC-12%Co and Al 2 O 3 as examples. These are two common coating materials widely used in wear resistant applications. A computerized detonation spraying system CCDS2000 (Computer-Controlled Detonation Spraying) was used for coating deposition. The roughness parameter of the WC-Co coating has a value of Ra = 3.95 μm and that of the Al2O3 coating has a value of Ra = 2.53 μm. To investigate the detonation coatings, the coating materials were characterized and microhardness measurements were carried out. Microhardness for stainless steel 12Х18Н10Т (AISI 321, 321H) – 392.32 Hv; for WC-12Co coating – 1332.3 Hv and Al 2 O 3 – 805.50 Hv. By results of researches the greatest resistance to all kinds of wear has coatings WC-12%Co. Al 2 O 3 coatings can also be recommended for operation under sliding wear conditions.
Сведения
- Журнал
- NNC RK Bulletin
- Опубликовано
- 2023 · № 3, С. 168-173
- Язык
- Английский
- Цитирований
- 2
- ISSN
- 1729-7516 · 1729-7885
- Издатель
- Republican State Enterprise "National Nuclear Center of the Republic of Kazakhstan
- Аффилиации
- Plasma Science LLP
Sarsen Amanzholov East Kazakhstan University
Plasma Science LLP; Sarsen Amanzholov East Kazakhstan University
Daulet Serikbayev East Kazakhstan Technical University