Central AsianResearch Index

Comparison of the Accuracy of Measurements of the Geometry of Parts Using Coordinate Measuring Machines in Manual and Programmed Operating Modes

This study compares the accuracy and repeatability of dimensional measurements performed on a coordinate measuring machine in manual and programmed operating modes. A Cummins diesel-engine piston was used as the test object; its diameter was measured in a production-specified section located 119 mm from the pistonskirt end. The experiment comprised part fixturing, establishment of the workpiece coordinate system by the 3-2-1 method, and repeated measurements in both modes. A Mezorix Atlas C 686 Basic CMM equipped with a Renishaw TP20 probe was used. In manual mode, the self-learning function recorded contact-point coordinates and approach vectors. In programmed mode, the RationalDMIS routine refined approach vectors according to nominal geometry and maintained a controlled contact speed. Ten repeated measurements were completed in each mode, and manualmode reproducibility was additionally evaluated by three operators. The programmed mode produced a mean diameter of 157.7548 mm, a standard deviation of 0.0012 mm, and an uncertainty of ±0.0024 mm. The corresponding manualmode values were 157.7382 mm, 0.0057 mm, and ±0.0114 mm. Relative to manual control, programmed control reduced the absolute deviation from the nominal diameter by 39.1% and the standard deviation by a factor of 4.75. The results show that automated control improves measurement repeatability by stabilizing probe direction and speed, whereas manual measurement remains dependent on operator skill. Self-learning is recommended for rapid generation of an initial inspection program followed by software-based optimization.

Сведения

Опубликовано
2026 · № 3, С. 3
Язык
Английский
ISSN
2706-977X
Издатель
Karaganda Technical University named after Abylkas Saginov
Аффилиации
State University of Management