Central AsianResearch Index

Experimental Investigation of Thermofriction Milling with Pulsed Cooling for Improving the Machinability of Hadfield Steel

Hadfield steel is widely used for components subjected to severe impact and abrasive wear; however, its pronounced work-hardening behavior significantly complicates conventional machining. This study experimentally investigates thermofriction milling with pulsed cooling as an alternative approach for machining 110G13L Hadfield steel. The experiments were conducted using a specially designed friction cutter with a diameter of 250 mm. The investigated machining parameters included spindle speeds of 500–2000 rpm, feed rates of 40–600 mm/min, and depths of cut of 1–5 mm. Surface roughness and hardness were evaluated to characterize the effect of the machining parameters on the resulting surface condition. The results showed that increasing spindle speed reduced surface roughness, whereas increasing feed rate increased roughness. Under favorable machining conditions, a surface roughness of (Rz leq 10) μm was achieved. Surface hardness increased with both spindle speed and feed rate, indicating intensive thermomechanical modification of the machined layer. The experiments confirmed the feasibility of thermofriction milling with pulsed cooling for processing Hadfield steel while also revealing limitations related to surface quality and chip fragmentation. The obtained results provide an experimental basis for the further development of a combined machining method integrating thermofrictional and conventional cutting mechanisms.

Сведения

Опубликовано
2026 · № 3, С. 122
Язык
Английский
ISSN
2706-977X
Издатель
Karaganda Technical University named after Abylkas Saginov
Аффилиации
Abylkas Saginov Karaganda Technical University
S.Seifullin Kazakh Agro Technical University
Aktobe Regional State University named after K.Zhubanov