Effect of Nickel Content on Tensile, Hardness Properties and Dry Sliding Wear Behaviour of Austempered Ductile Iron
The increasing interest in the development of austempered ductile cast irons has led to a great deal of study being done on their physical metallurgy and mechanical properties. The exceptional strength and hardness of these cast irons are well recognised. In this study, samples of permanent moulded toughened austempered ductile iron (PMADI) that are subjected to an austempering heat treatment are used to investigate the effects of nickel content on their tensile strength and hardness strength. PMADI samples were developed using Casting and samples with 1% nickel 2% Nickel content were prepared. The characteristics of PMADI samples were compared with those of samples that had been hardened and subjected to normal austempering heat treatment. Investigations were conducted on mechanical characteristics, such as tensile and hardness tests. ADI samples have shown higher levels of hardness and tensile strength. The findings showed that the mechanical characteristics of PMADI samples with 2.0% nickel were noticeably better. The scanning electron microscopy images revealed both ductile and brittle mode of fracture. Wear testing was conducted utilising a pin-on-disk machine in dry sliding method. Large quantities of austenite, which are produced at higher austempering temperatures, help to increase wear resistance through martensitic transformation. The coarse ausferrite structure in ADIs experiences adhesion, delamination, and mild abrasion in addition to oxidational wear, according to an analysis of worn surfaces and the kind of wear debris. An increase in mechanical strength seems to be correlated with an increase in retained austenite content.
Сведения
- Опубликовано
- 2026 · № 1, С. 46
- Язык
- Английский
- ISSN
- 2706-977X
- Издатель
- Karaganda Technical University named after Abylkas Saginov
- Аффилиации
- Sai Vidya institute of Technology
S.J.C Institute of Technology
REVA University
Ballari Institute of Technology & Management