Central AsianResearch Index

Evaluation of the Structural Strength of a Prefabricated Milling Cutter with Replaceable inserts During Machining

Simulation modeling of the stress state of a prefabricated milling cutter with replaceable inserts during machining was carried out in the ABAQUS 2020 program using the finite element method. It has been established that the structural strength of a cutting tool depends on the geometry, material and cutting conditions. Based on the simulation, stress concentrators in a milling cutter with replaceable inserts were identified. The safety factor of the structure has also been determined, which meets the standard requirement. It has been established that a prefabricated milling cutter with replaceable plates during machining under extreme conditions ensures its performance with a margin of 20%. Thus, a prefabricated cutter with replaceable inserts is applicable for machining newly created and restored surfaces after hardfacing.

Сведения

Опубликовано
2023 · Т. 4
Язык
Английский
Цитирований
7
ISSN
2706-977X
Издатель
Karaganda Technical University named after Abylkas Saginov