Central AsianResearch Index

Effect of Microalloying with Ferrosilicon Boron on the Properties of Improved 30ХН2МА Steel

The study was conducted to evaluate the possibility of adjusting the composition of the improved 30ХН2МА steel through microalloying with ferrosilicon boron, enabling its subsequent use as a wear-resistant material with properties comparable to Hardox steel. 30ХН2МА steel served as the base material, and ferrosilicon boron was added during the final minutes of melting. The boron content in the ferrosilicon boron was 0.9%, and the silicon content was 62%. Incorporation of this complex alloy allowed the steel to be simultaneously partially deoxidized and microalloyed with boron at a concentration of 0.002-0.003%. It was determined that, at a tempering temperature range of 400-450°C, its hardness, tensile strength, and wear resistance approach the corresponding parameters of Hardox 500 steel, supporting its recommendation as a wear-resistant material. Considering the widespread use of 30ХН2МА steel, its high hardenability, relatively good casting properties, low sensitivity to temper brittleness, and enhanced mechanical properties after boron microalloying, it can be considered a suitable wear-resistant material for the production of shaped castings

Сведения

Журнал
Trudy Universiteta
Опубликовано
2026 · Т. 2, № 103, С. 28
Язык
Английский
ISSN
1609-1825 · 2710-3382
Издатель
Karaganda Technical University named after Abylkas Saginov
Аффилиации
Zh. Abishev Chemical-Metallurgical Institute
Karaganda Medical University
Navoi State Mining and Technological University