Obtaining Zinc Oxide by Polarization of Zinc Electrode with Alternating Current in Sodium Chloride Solution
The purpose of the work is to dissolve the zinc electrode during polarization with an alternating current with a frequency of 50 Hz and to obtain zinc oxide. It is shown that the pre-recorded anode-cathode cyclic potentiodynamic polarization curves allow to predict to a certain extent the processes occuriing on the zinc electrode during alternating current polarization. It has been established that when two zinc electrodes are polarized in sodium chloride with an alternating current with a frequency of 50 Hz, they do not dissolve, but when one electrode is replaced with a titanium one, zinc dissolves intensively with the production of zinc hydroxide. It is shown that the rate of zinc dissolution directly depends on the current density at the titanium electrode. When the values of the current density on the titanium electrode change in the range of 5-10 kA/m2, the zinc dissolution current efficiency exceeds 100%. Based on the results of the research, it was established that zinc (II) hydroxide is produced during electrolysis, and zinc oxide can be obtained by dehydration. The composition of the resulting compound was identified by X-ray phase and elemental analyses
Сведения
- Журнал
- Trudy Universiteta
- Опубликовано
- 2024 · Т. 1
- Язык
- Английский
- ISSN
- 1609-1825 · 2710-3382
- Издатель
- Karaganda Technical University named after Abylkas Saginov