Central AsianResearch Index

Study of Asymmetric Rolling Process Using Truncated Cone-shaped Shafts with a Convex Working Surface

The article describes the results of the study of the process of asymmetric rolling using truncated cone-shaped shafts with a convex working surface. The possibility of occurrence of shear deformations, which positively affects the quality of the material to be trampled, has been proven by using the proposed special trampling shafts. Experimental studies were carried out using the method of multi-layered models. As a result of the analysis, it was found that the angle of inclination of the layers γ increases with the increase in the degree of compression ε during asymmetric treading on cone-shaped shafts with a convex working surface. As a result of tapping, it was concluded that the intensity of the shear deformation, which reaches 2÷2.5 during one pass, increases.

Сведения

Журнал
Trudy Universiteta
Опубликовано
2023 · Т. 3
Язык
Английский
ISSN
1609-1825 · 2710-3382
Издатель
Karaganda Technical University named after Abylkas Saginov