Central AsianResearch Index

Technology of Processing of Ash and Slag Waste of Thermal Power Plants by Sintering

The aim of the study is to select the optimal composition of the sintering charge for maximum extraction of alumina. The experiments have shown that sintering using two-component charges allows to extract alumina from the obtained sinters by no more than 60%. The highest sintering rates were obtained using three-component charges. Thus, when using ash and slag waste from Almaty CHPP-2, the extraction of alumina amounted to 83.68% on the charge of the composition CaO : SiO2 = 2; Na2O : (Al2O3 + Fe2O3) = 1 during sintering in the interval of 60 minutes at a temperature of 1200°С, under the same conditions, 87.07% recovery was obtained for ash and slag waste of the Eurasian Energy Corporation, for ash and slag waste after chemical activation, recovery was – 90.2%. The experiments have shown that the production of self-disintegrating sinters suitable for further processing from the tested samples of ash and slag waste is possible with the use of three-component charges

Сведения

Журнал
Trudy Universiteta
Опубликовано
2022 · С. 103
Язык
Английский
Цитирований
1
ISSN
1609-1825 · 2710-3382
Издатель
Karaganda Technical University named after Abylkas Saginov
Аффилиации
D. Serikbayev East Kazakhstan State Technical University
S. Toraighyrov Pavlodar State University
Kazakh National Research Technical University named after K.I. Satpayev