Central AsianResearch Index

DEVELOPMENT OF A FLEXIBLE TECHNOLOGICAL REGULATION FOR QUALITY CONTROL OF HOT-PRESSED BERYLLIUM

This paper presents the results of statistical studies on the quality stabilization of beryllium semi-finished products obtained by vacuum hot pressing. The quality of hot-pressed products, as regulated by technical specifications, is primarily characterized by impurity content and physical-mechanical properties. The main unstable parameter is the ultimate tensile strength. The article examines the causes of instability in the strength characteristics of technical-grade beryllium produced by powder metallurgy under industrial manufacturing conditions. Correlation analysis revealed the primary factors determining the quality of beryllium in terms of its mechanical properties. It is shown that the silicon impurity exerts a softening effect on hot-pressed beryllium. An increase in silicon content from 0.01–0.02 % to 0.02–0.03 % leads to a decrease in average tensile strength values from 377 to 357 MPa and increases the rejection rate from 6 % to 40 %. The authors propose a mathematical model for predicting the strength properties of sintered beryllium, derived through regression analysis, which accounts for the combined influence of the chemical and physical characteristics of the powders, as well as the consolidation parameters. The model enables the determination of optimal pressing parameters, ensuring stable quality of the finished products and, consequently, a reduction in the production rejection rate. Keywords: Technical-grade beryllium, powder metallurgy, vacuum hot pressing, tensile strength, correlation and regression analysis.

Сведения

Опубликовано
2026 · № 3,2026, С. 411-423
Язык
Английский
ISSN
1680-9165 · 2788-8770
Издатель
Toraighyrov University