Central Asian Research Index

Science and Technology of Kazakhstan, 2026, № 3,2026, с. 239-260

WAAM OF LOW-CARBON STEEL USING MIG WELDING UNDER EQUIVALENT CONDITIONS

E. S. Chukenova, Y. Z. Nugman, A. K. Mustafa, M. К. Sagyntay, F. Khoshnaw

Аннотация · Abstract

In this study, the effect of arc process parameters on the microstructure and mechanical properties of samples produced from low-carbon steel wire using Wire Arc Additive Manufacturing (WAAM) technology was investigated. MIG/MAG welding and lathe machine facilities were used to establish deposition conditions like those of a WAAM system. The MIG/MAG welding machine acted as the heat source, while the lathe controlled the substrate motion to enable vertical layer-by-layer deposition. The samples were fabricated in MIG/MAG mode using a Magnetta 220 S welding system. During the experiments, the following process parameters were applied: welding current 53 A, voltage 14.8 V, torch travel speed 3.5 mm/s, and wire feed speed 3 m/min. Metallographic analysis revealed the formation of a directional solidification structure in the deposited samples. The microstructure mainly consisted of a ferritic matrix with pearlite colonies, which ensures a favorable balance between strength and ductility. Moreover, microhardness measurements ranged from 154–166 HV1, with an average of 161 HV1. The results show that the low-carbon steel produced by WAAM technology exhibits a relatively uniform microstructure and high mechanical strength characteristics. Keywords: Additive manufacturing, WAAM technology, low-carbon steel, microstructure, mechanical properties.

Сведения · Details