Central AsianResearch Index

EFFECT OF ULTRASONIC COOLANT ON MILLING QUALITY AND TOOL WEAR

This article presents a computational assessment of the potential effects of ultrasonic regeneration of used cutting fluid on tool wear and selected milling-performance indicators. The study is relevant because used cutting fluids gradually accumulate solid particles, wear debris, tramp oils, and other contaminants, which can reduce their cooling and lubricating capacity and impair machining quality. A deterministic two-scenario model was used to compare milling with contaminated untreated fluid and with the same fluid after ultrasonic regeneration. Reductions in contamination were taken from previously published experimental data, whereas flank-wear trajectories, tangential cutting force, and surface roughness were defined as scenario assumptions. The calculations showed that ultrasonic regeneration reduced solid-particle concentration by 70.3 %, turbidity by 63.0 %, mean particle size by 57.5 %, and tramp-oil content by 56.2 %. In the regenerated-fluid scenario, final flank wear decreased from 0.433 to 0.310 mm, corresponding to a 28.4 % reduction. Estimated tool life increased from 45.0 to 58.6 min, or by 30.2 %. Tangential cutting force decreased from 150.5 to 132.4 N, and surface roughness (Ra) decreased from 1.483 to 1.195 μm, corresponding to improvements of 12.0 % and 19.4 %, respectively. For 1000 min of milling, projected cutting-tool expenditure decreased from 400,000 to approximately 307,167 tenge, with an estimated saving of 92,833 tenge. The results suggest that ultrasonic regeneration may be useful for cutting-fluid management, but the findings remain preliminary and require experimental verification. Keywords: ultrasonic cleaning, cutting fluid, milling, tool wear, tool life, cutting force, roughness, process stability.

Сведения

Опубликовано
2026 · № 3,2026, С. 182-197
Язык
Английский
ISSN
1680-9165 · 2788-8770
Издатель
Toraighyrov University