Central Asian Research Index

Science and Technology of Kazakhstan, 2023, № 3,2023, с. 93-101

"STRESS-DEFORMABLE STATE OF GLASS DURING WATERJET CUTTING"

G. M. Bazenov, G.T. Itybayeva, R. B. Kussainov, A. L. Galinovskiy, Zh. K. Mussina

Аннотация · Abstract

"The most common modern technology for cutting float glass is cutting with cutting wheels, which have a wedge-shaped obtuse cross section and are made of hard alloys. Cutting glass is the creation of a system of cracks. During this, an area of destruction is inevitably formed, consisting of a large number of tiny digs and cracks that occur because of the action of the cutting tool. In the process of waterjet cutting, the depth of surface and lateral cracks increases. In addition, this increases the variation in the depth of the middle cracks. These factors worsen the quality of the cut and increase the likelihood of a split not along the cut. All this results in the necessity to ensure the wheel sharpening angle, pressure and cutting speed that are optimal for the quality of the cut. These optimal values depend on the thickness of the glass and the retained stresses in the glass. The quality of the cut depends on the number and depth of microcracks (especially the middle ones). With a decrease in the angle of sharpening of the wheel, an increase in cutting pressure and speed, the average depth of the median cracks increases, which has a positive effect on the quality of the cut. As a result of the conducted research, optimal parameters of waterjet cutting (treatment) were established, namely, the angle of sharpening of the wheel (110°-160°), cutting pressure (35 N) and speed, which is favorable for the quality of the cut and a reduction in the reject percentage. Keywords: stress-deformable state, glass, waterjet cutting, wheel, sharpening, sharpening angle. "

Сведения · Details