Science and Technology of Kazakhstan, 2026, № 2, 2026, с. 240-255
TRIBOCORROSION PROPERTIES OF ALLOY STEEL BORIDE LAYERS AFTER THERMOCYCLIC ELECTROLYTIC-PLASMA BORIDING
Аннотация · Abstract
This article presents the results of a study of the tribocorrosion resistance of 30KhGSA alloy steel after diffusion thermocyclic electrolytic-plasma boriding (DTEPB). The aim of the study is to evaluate the influence of DTEPB parameters on the formation of the surface layer structure and its behavior under tribocorrosion conditions. The study utilized tribocorrosion tests with simultaneous recording of the friction coefficient and electrochemical parameters, potentiodynamic analysis, as well as scanning electron microscopy and energy-dispersive analysis. It was found that the treatment leads to the formation of a dense boride layer, which significantly increases the material’s resistance to tribocorrosion destruction. Optimum characteristics are achieved with a 30 % sodium tetraborate content in the electrolyte: the wear rate is reduced to 1.036×10⁻⁴ mm²/N m, and the corrosion rate is reduced to 0.00685 mm/year. It has been shown that increasing the number of thermal cycles reduces the defectiveness of the boride layer and enhances its protective properties. The formation of a two-layer structure (oxide and boride layers) reduces the friction coefficient and limits the development of tribocorrosion processes. The obtained results confirm the effectiveness of DTEPB as a method for increasing the tribocorrosion resistance of alloy steels. Keywords: electrolytic-plasma boriding, tribocorrosion, alloy steel, friction coefficient, wear rate.
Сведения · Details
- DOI 10.48081/bgqf2228
- Журнал · Journal Science and Technology of Kazakhstan
- Язык · Language английский
- Цитирования (Crossref) · Citations 0