Central Asian Research Index

Science and Technology of Kazakhstan, 2026, с. 210-220

"STUDY OF THE FORMATION OF SECONDARY CONTACT STRUCTURE "

G. M. Tussupbekova, J. Cieślik, N. B. Tulieva, G. D. Tazhenova, G. Zh. Oryntaeva

Аннотация · Abstract

"Research conducted in the conditions of domestic machine-building industries has shown that one of the main factors leading to an increase in the cost of machining parts is the excessive consumption of metal-cutting tools due to their premature wear. The solution to this problem may be the development of a method to increase the wear resistance and durability of a metal-cutting tool, as newly acquired before it is used in mechanical processing, as the after overworking the restored one. This article presents the results of a study on the formation of a hardened secondary contact structure on the working surface of a tool after running-in, which is recommended as a way to increase the wear resistance and durability of a metal-cutting tool. It was found that the optimal pre-working modes of the tools provide the best deformation and thermal conditions for hardening the cutting part of the tools. The results of the study showed that, indeed, after running-in, a hardened layer forms on the cutting part of metal-cutting tools. It was found that the thickness of the hardened layer of the cutting part of the disk modular milling cutter is 0.41 mm, the cup cutter is 0.33 mm and the end milling cutter is 0.37 mm. A comparison of the results of experimental, computer and metallographic studies confirmed that after running-in, the cutting part of the tool hardens. Keywords: Running-in, metal cutting tool, wear, hardened layer, secondary contact structure, microstructure, temperature.

Сведения · Details