Central AsianResearch Index

INVESTIGATION OF USED MOTOR OIL HYDROCRACKING USING READILY AVAILABLE CATALYSTS

Used motor oils are a type of industrial waste that poses a significant threat to the environment; therefore, the development of efficient and resource-saving methods for their processing is an important task. The aim of this work is to develop catalysts based on natural and industrial raw materials for the hydrocracking of used motor oils under hydrogen pressure and to investigate their catalytic properties. Natural zeolite from the Shankanay deposit and red mud, an industrial waste generated by the Pavlodar Aluminium Plant, were used for catalyst preparation. The natural zeolite was subjected to ion-exchange and thermal treatment and modified with molybdenum to enhance its catalytic activity. The composition, structure, and morphology of the obtained materials were investigated using X-ray diffraction analysis, infrared spectroscopy, X-ray spectral analysis, and scanning electron microscopy. Physicochemical studies showed that the aluminosilicate structure of the Shankanay zeolite based on clinoptilolite was preserved. The presence of Fe2 O3 , TiO2 , SiO2 and Al2 O3 phases in the red mud indicated its ability to form catalytically active sites. In the molybdenum-modified zeolite systems, the clinoptilolite structure was preserved, and MoO3 and Fe2 O3 phases were identified. The effective technological conditions for the hydrocracking of used motor oils were determined as follows: initial feedstock mass of 40 g, temperature of 420 °C, initial hydrogen pressure of 1.0 MPa, process duration of 60 min, and catalyst mass of 1.0 g. Under these conditions, the total yield of liquid products was 83.32% in the presence of calcined red mud and 81.65% in the presence of 4% Mo/Shankanay zeolite. The obtained results demonstrate the potential of modified catalytic systems based on red mud and natural zeolite for the conversion of used motor oils into motor fuel fractions.

Сведения

Журнал
Neft i gaz
Опубликовано
2026 · Т. 155, № 5, С. 315-326
Язык
Английский
ISSN
1562-2932 · 2708-0080
Издатель
Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan
Аффилиации
SCIENTIFIC RESEARCH INSTITUTE FOR NEW CHEMICAL TECHNOLOGIES AND MATERIALS
AL-FARABI KAZAKH NATIONAL UNIVERSITY
D.V. SOKOLSKY INSTITUTE OF FUEL, CATALYSIS AND ELECTROCHEMISTRY