The effect of ED-20 epoxy resin and used engine oil on the properties of modified bitumen
Waste disposal has become an environmental concern in many parts of the world. With the growth of automobile production, the amount of used tires and motor oil is steadily increasing. The global production of tires exceeds 1.5 billion units per year, with approximately 1,089,000 tons – or more than 66 million tires – being recycled into the crumb rubber market. Moreover, the volume of discarded motor oil has surpassed 10 million barrels. As a result, the need has arisen to utilize these waste materials in engineering applications. In addition, combined additives are increasingly being used in the modification of road bitumen to achieve improved performance characteristics. This article investigates the effect of epoxy resin ED-20 and used motor oil (UMO) on the physicomechanical properties of bitumen modified with 15% crumb rubber. The aim of the study is to determine the optimal ratio of modifying additives to improve the performance characteristics of the bituminous binder. During the experiment, the epoxy resin content varied from 0 to 6%, and the used oil content ranged from 2% to 6%. The key parameters evaluated were softening point, penetration, ductility, and brittle point temperature. It was found that moderate contents of resin (2-4%) and oil (2-4%) provide the best combination of thermal stability, elasticity, and frost resistance. Increasing the epoxy resin to 6% in combination with 6% oil leads to deterioration of properties: reduced ductility, increased brittle temperature, and disruption of structural integrity due to possible phase separation. The results obtained make it possible to recommend rational proportions of additives for the production of high-quality bitumen suitable for road construction under variable temperature conditions and heavy loads.
Сведения
- Журнал
- Neft i gaz
- Опубликовано
- 2025 · Т. 150, № 6, С. 282
- Язык
- Английский
- ISSN
- 1562-2932 · 2708-0080
- Издатель
- Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan