The use of high-speed thermal technologies in the repair of main pipelines
This paper discusses the use of supersonic thermal tools in the repair of trunk oil and gas pipelines in the conditions of the Republic of Kazakhstan. The length of pipeline systems exposed to aggressive climatic and operational impact requires modern technologies for restoring insulation coatings. Particular attention is paid to the use of thermal gas jet methods using reactive burners of type TRV-12M, which provide high productivity due to thermal destruction of polymer films. The advantages of this method are the absence of mechanical contact with the surface, the high temperature of the jet (up to 2500-3500 °K) and the gas flow rate (up to 2000 m/s), which makes it possible to effectively remove the old coating without damaging the metal of the pipe. The results of experimental studies to determine the optimal angles of inclination of the burner, distances from the nozzle to the surface and thermal characteristics of the process are presented. Calculations show that the process capacity can reach 10 m ²/h, subject to the process parameters. Various insulation defects, causes of premature corrosion and factors that reduce the adhesion of the insulation layer to the metal surface were also analyzed. The developed technique allows you to calculate the cleaning performance of pipes of various diameters and coating thicknesses, which gives the basis for the creation of mechanized installations of a new generation. The data obtained confirm the prospects of using high-speed thermal tools in the overhaul of pipelines and provide the basis for the development of effective technologies for cleaning and restoring pipeline transport.
Сведения
- Журнал
- Neft i gaz
- Опубликовано
- 2025 · Т. 148, № 4, С. 107-117
- Язык
- Английский
- ISSN
- 1562-2932 · 2708-0080
- Издатель
- Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan