Assessment and recommendations for preventing tools and equipment from falling from a height
Drilling rigs have a height from 40 m to 52 m. This is due to the fact that to speed up the drilling process, two or three drill pipes are attached permanently, i.e. they do not unscrew during drilling. And the longer the drill plugs, the less time it will take to drill a certain well. And as the length of the drill pipe candle increases, the height of the drilling rigs also increases. Crown blocks are installed on the headrest of drilling rigs, i.e. at a height of about 45 m. During operation, maintenance is performed at this height. At the same time, service personnel will use locksmith and repair tools and devices, the fall of which is not excluded. Also, when performing descent and lifting operations, an accident with im-pacts of the lifting block moving upwards as a result of a collision with the crown block due to the negligence of the driller or the failure of the lifting limiter mech-anism of the lifting block in a timely manner is not excluded. As a result, it is also possible not only for small-sized and lower-weight parts and tools to fall, but also for the elements of the hoisting system to fall: the hoisting block, hook, etc. Since they have large masses, their amount of movement will be greater, and accordingly the negative consequences of their fall will be deplorable. To determine the time of the fall of the tool or equipment, a differential equa-tion of motion of the tool or equipment was found and by integrating this equa-tion, the time of the fall of the tool or equipment from the height of the drilling rig was determined. There are clear recommendations for securing tools, preventing tools from falling and improving workplace safety. The practical significance of the study lies in the fact that the results of the work performed on the topic "Assessment and recommendations for preventing the tools and equipment from falling from a height" can be used as a base for theoret-ical research, analytical and design activities of authors studying this area. The second aspect of the practical significance of this study is the possibility of using the results of the study within the framework of the topic "Assessment and recom-mendations for preventing the tools and equipment from falling from a height" in order to develop the mechanism of functioning of the object under study.
Сведения
- Журнал
- Neft i gaz
- Опубликовано
- 2024 · Т. 143, № 5, С. 121-131
- Язык
- Английский
- ISSN
- 1562-2932 · 2708-0080
- Издатель
- Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan