Application of carbon-mineral filler based on coal shale mining by-products in elastomeric compositions
The integration of biological and renewable resources as fillers or novel components in thermoplastics and rubbers has gained attention due to their potential to mitigate the environmental impact of petroleum- and natural gas-derived fillers. This study explored using a carbon-mineral filler, derived from coal shale processing by-products, as a partial or complete substitute for standard industrial fillers in rubber formulations for sealing materials. Six rubber compositions were produced, varying in the proportion of carbon-mineral filler replacing N550 semi-reinforcing carbon black, and were evaluated for viscoelastic, kinetic, physical-mechanical, structural, and operational properties. Fully substituting technical carbon with the carbon-mineral filler improved technological characteristics, reducing Mooney viscosity by 40.5% and increasing resistance to premature vulcanization by 53.6%. When up to 10 wt.% of N550 was replaced, the materials retained required strength and hardness. Moreover, the elasticity of rubbers increased by up to 1.5 times with higher filler content. Even at elevated substitution levels, sealing performance remained stable, while resistance to aggressive liquid media nearly doubled (up to 1.9 times). These findings suggest that the carbon-mineral filler can extend the service life of rubber sealing products while reducing reliance on conventional fillers.
Сведения
- Опубликовано
- 2025 · Т. 152, № 3, С. 58-75
- Язык
- Английский
- ISSN
- 2616-6771 · 2617-9962 · 3107-278X · 3135-209X
- Издатель
- L. N. Gumilyov Eurasian National University