Central AsianResearch Index

CORN-COB-DERIVED Fe-MODIFIED ACTIVATED CARBONS FOR PARACETAMOL AND SULFAMETHOXAZOLE REMOVAL BY ADSORPTION AND OXIDATIVE TREATMENT

Fe-modified activated carbons were prepared from corn-cob-derived activated carbon by wet impregnation with ferric nitrate, followed by thermal treatment under nitrogen. The obtained materials, denoted MAC1, MAC2.5, and MAC5 according to their nominal iron loadings, were evaluated for the aqueous-phase removal of paracetamol (PCM) and sulfamethoxazole (SMX) by adsorption and oxidant-assisted treatment using hydrogen peroxide and sodium persulfate (SPS). The experiments were conducted with an initial pollutant concentration of 50 mg L-¹, a material dose of 2.5 g L-¹, pH 3.5, and 60 °C for up to 24 h. Hydrogen peroxide and SPS were each used at an initial mass concentration of 44.3 mg L-¹, corresponding to 1.30 mmol L-¹ H₂O₂ and 0.186 mmol L-¹ Na₂S₂O₈. The residual oxidant concentration was monitored during treatment, and samples were chemically quenched before HPLC analysis. Under the tested model-water conditions, the highest experimental adsorption uptake was 17.08 mg g-¹ for PCM on MAC5 and 7.52 mg g-¹ for SMX on MAC2.5. The SPS-assisted systems produced a greater decrease in the aqueous concentration of the parent compounds than the hydrogen-peroxide-assisted systems, with PCM removal above 98% and SMX removal up to 74% after 24 h. These values represent aqueous-phase removal and do not by themselves distinguish adsorption from chemical transformation. The results indicate that iron loading, porous structure, pollutant speciation, and oxidant consumption jointly influence the observed performance.

Сведения

Журнал
REPORTS
Опубликовано
2026 · № 3
Язык
Английский
ISSN
2224-5227 · 2518-1483
Издатель
Central Asian Academic Research Center LLP