STRUCTURAL AND CATALYTIC PROPERTIES OF SCS-DERIVED Co–Al–Mg–Mn CATALYSTS IN DRY REFORMING OF METHANE
The production of valuable syngas through the dry reforming of methane is one of the important directions in modern catalytic technologies. In this study, Co-Al-Mg-Mn-based catalysts were prepared by the solution combustion synthesis (SCS) method, using metal nitrates as precursors of the active phase and urea as a fuel. The phase composition, textural properties, and morphology of the prepared samples were investigated by XRD, BET, SEM, and EDS techniques. XRD analysis revealed the formation of CoAl2O4, MgAl2O4, Co3O4, CoO, and mixed metal oxide phases, confirming the development of a complex multicomponent oxide structure. BET results showed that the specific surface area, pore volume, and pore diameter strongly depend on the catalyst composition, while SEM-EDS analysis confirmed a porous aggregated morphology and the presence of Co, Al, Mg, Mn, and O elements in the catalyst. Among the investigated samples, the 20Co-20Al-5Mg-5Mn/50 urea catalyst exhibited the highest activity in the dry reforming of methane. Under optimal conditions, CH₄ and CO₂ conversions reached approximately 98,8%, while H2 and CO selectivities were 100,0% and 99,5%, respectively. The obtained results indicate that Co-Al-Mg-Mn-based catalysts are promising materials for syngas production, and that the SCS method is an effective approach for preparing porous and catalytically active multicomponent catalysts.
Сведения
- Журнал
- REPORTS
- Опубликовано
- 2026 · № 2
- Язык
- Английский
- ISSN
- 2224-5227 · 2518-1483
- Издатель
- Central Asian Academic Research Center LLP