THE INFLUENCE OF PEPA CONCENTRATION ON THE PHYSICAL, MECHANICAL AND OPERATIONAL PROPERTIES OF ED-20 EPOXY ADHESIVES
In this work, the effect of different concentrations of polyethylenepolyamine (PEPA) hardener (8%, 12% and 16%), as well as polysulfone modifier and aluminosilicate clay filler on the properties of adhesive compositions based on ED-20 epoxy-diane resin was studied. During the study, two different compositions of adhesive compositions were prepared and their structural, physicomechanical and operational properties were comprehensively evaluated. The chemical structure of ED-20 epoxy resin and PEPA hardener was determined by infrared (IR) spectroscopy and proved to be fully consistent with standard compositions. The obtained IR spectral data confirmed the preservation of epoxy and amine groups and their ability to effectively interact with each other. Experimental results showed that the amount of PEPA in the adhesive composition significantly affects the pH value, strength, water and heat resistance, dynamic viscosity and workability. All studied compositions met the requirements of the ST 33122-2022 standard. The adhesive composition with a PEPA content of 12% was determined as the most effective and balanced option in terms of the set of properties. The results obtained allow optimizing the composition of epoxy adhesives and expanding their scope of application in the chemical industry and mechanical engineering.
Сведения
- Журнал
- REPORTS
- Опубликовано
- 2026 · Т. 1, № 357
- Язык
- Английский
- ISSN
- 2224-5227 · 2518-1483
- Издатель
- Central Asian Academic Research Center LLP